?

Log in

Fri, Feb. 12th, 2010, 12:20 pm
subinpthomas: Beginner in VxWorks Driver Development

I am a beginner in VxWorks and I am trying to implement a driver for the D-Link Fast Ethernet Card DFE 530TX which uses the VT86C100A chip as part of my Academic Career. I couldn't find any helpful information on this yet. Can anyone give me some help?

Fri, Feb. 12th, 2010 06:39 pm (UTC)
subinpthomas

Yes I have the data sheet and referring the Realtek deriver. But in Linux driver for the same they have defined a register at 0x54 (FIFO Test) but i am not seeing it in data sheet. Thank you very much for the reply and I am waiting for more help.. as there is very much difference in capabilities and registers in both. In the datasheet I am also seeing PCI Function 0 Registers as an additional set where as in RTL there is only one set and it include vendor Id and all. Here in VT there is two set of registers. The one I have mentioned contain IDs and one more set is there under Memory-Space Register Summary. So I am little bit confused. Now I am completing the #defines. Would you mind reviewing it? If not where should I post it?